Victron Orion-TR Smart 12/12-30 30A (360W) Isolated DC-DC or Power Supply

Orion-TR Smart 12/12-30A (360W) Isolated DC-DC Charger or Power SupplyThe Orion-Tr Smart isolated DC-DC charger serves as a DC-DC battery charger or a power supply (also designed for use as a constant voltage source), offering a wide input and output voltage range. This is especially significant in the case of vehicles with a Euro 5 or Euro 6 smart alternator, which often supplies too low charging voltage even when the engine is running or when extended cable lengths, as is often the case in boats and RVs, lead to voltage drops. In such scenarios, precise and controlled charging is imperative to fully charge the service battery while protecting the starter/input battery from discharge.Bluetooth Smart EnabledAny Bluetooth-enabled smartphone, tablet, or other device can be used to monitor, change settings, and update the charger when new software features become availableInstant Readout: The VictronConnect App can display key data, including warnings and alarms, on the device list page without the need to connect to the productFully programmableBattery charge algorithm (configurable) or fixed output.Smart Alternator Compatibility: engine running detection mechanismAdaptive 3-Stage Charge Algorithm: Bulk Absorption FloatFor lead-acid batteries, it is important that during shallow discharges the absorption time is kept short to prevent overcharging of the battery. After a deep discharge, the absorption time is automatically increased to make sure that the battery is completely rechargedFor lithium batteries, the absorption time is fixed; the default is 2 hoursAlternatively, a fixed output voltage can be chosenSuitable for Use in Vehicles with a Smart Alternator (Euro 5 and Euro 6 Engines)The built-in engine shutdown detection will stop the converter when the engine is not running. This prevents unwanted discharge of the starter battery (see manual for details).Remote On/OffA remote on/off switch or relay contact can be connected to a two-pole connector. Alternatively, the H terminal (right) of the two-pole connector can be switched to battery plus, or the L terminal (left) of the two-pole connector can be switched to battery minus (or the chassis of a vehicle, for example).All Models Are Short Circuit Proof and Can Be Paralleled to Increase Output CurrentAn unlimited number of units can be connected in parallel.High Temperature ProtectedThe output current will reduce at high ambient temperatures.IP43 ProtectionWhen installed with the screw terminals oriented downward.Screw TerminalsNo special tools are needed for installation. Input fuse (not replaceable)*Input fuse (not replaceable)Specifications:Input Voltage Range: 10-17 VUnder Voltage Shut Down: 7 VUnder Voltage Restart: 7.5 VNominal Output Voltage: 12.2 VOutput Voltage Adjust Range: 10-15 VOutput Voltage Tolerance: +/- 0,2 VOutput Noise: 2 mV rmsCont. Output Current at Nominal Output Voltage and 40 Degrees C: 30 AMaximum Output Current (10 S) at Nominal Output Voltage minus 20%: 40 AShort Circuit Output Current: 60 ACont. Output Power at 25 Degrees C: 430 WCont. Output Power at 40 Degrees C: 360 WEfficiency: 87 %No Load Input Current (2): < 80 mAStandby Current: Less than 1ACan Be Used as Power Supply: Yes, output voltage can be set with BluetoothGalvanic Isolation: 200 VDC between input, output, and caseOperating Temperature Range -20 to +55 C (derate 3 % per C above 40 C)Humidity: Max. 95 % non-condensingDC Connection: Screw terminalsMaximum Cable Cross-Section: 16 mm AWG6Weight: 1,8 kg (3 lb)Dimensions (H x W x D):130 x 186 x 70 mm (5.1 x 7.3 x 2.8 inch)Protection Category IP43 (electronic components), IP22 (connection area)Safety Standards: EN 60950Emission/Immunity Standards: EN 61000-6-3, EN 55014-1 / EN 61000-6-2, EN 61000-6-1, EN 55014-2Automotive Directive Standards: ECE R10-5WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.Please contact your dealer for any returns, repairs or support issues related to this product. Specifications:Charger Output - Amps: 30aCharger Input - Voltage: 12vPortable: NoCharging Banks: 1Charger Output Voltage: 12vBox Dimensions: 4"H x 6"W x 9"L WT: 4.45 lbsUPC: 8719076047698Quick Guide (pdf)Owner's Manual (pdf)Brochure (pdf)